CHAPTER 6: ACTUAL VALUES
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 6–41
PASSCODE Z SETTINGS ACCESS settings value is Restricted. This message also appears
anytime that settings access is permitted and the access jumper is removed.
• THIS FEATURE NOT PROGRAMMED: If an attempt is made to enter an actual value
message subgroup, when the settings are not configured for that feature, this
message will appear.
• TIME ENTRY WAS NOT COMPLETE: Since the
TIME settings has a special format (HH/
MM/SS.S), if
ENTER is pressed before the complete value entered, this message
appears and the new value is not stored. Another attempt will have to be made with
the complete information.
• TIME ENTRY WAS OUT OF RANGE: If and invalid entry is made for the time (e.g. 35
entered for hour), this message will appear.
• TOP OF LIST: This message will indicate when the top of subgroup has been reached.
• TOP OF PAGE: This message will indicate when the top of a page has been reached.
To Next Page
Loading...
