37
7. Siren test
This option triggers the internal siren for three seconds followed by the external siren for three seconds
and finally the flash for 10 seconds.
Press 7 and [ENTER]. The display shows:
1- Confirm Siren Test
0-Exit, Menu:
Then press:
• 1 and [ENTER] to confirm that the control panel will start the siren test, or
• 0 and [ENTER] to return the menu, or
• [ENTER] to return to the menu.
8. Voice report
phone number
This option allows you to change the first telephone number of Central Station 4, if a voice reporting
protocol on this Central Station is programmed.
Press 8 and [ENTER]. The display shows:
"*"-Pause, Ph No:
Ph1:
Then:
• Enter the voice reporting telephone number (up to 10 digits) and press [ENTER], and/or
• Press [ENTER] to save the displayed telephone number. Follow the instructions described
above.
• 0 and [ENTER] to return the menu, or
• [ENTER] to return to the menu.
9. Stop voice
reporting
This option allows you to stop voice reporting for any Central Station programmed for Voice Reporting.
Press 9 and [ENTER]. The display shows:
1-Confirm Stop Voice Reporting
0-Exit, Menu:
Then press:
• 1 and [ENTER] to confirm stop voice reporting (the control panel then sends a "Stop Voice"
command to stop the reporting), or
• 0 and [ENTER] to return to the menu, or
• [ENTER] to return to the menu.
10. RAS test Tests the LEDs, the LCD display and buzzer of the RAS you are working with.
Enter 10 and press [ENTER]. The display shows:
1- Confirm RAS Test
0-Exit, Menu:
Then press:
• 1 and [ENTER] to confirm that the control panel will start the RAS test, or
• 0 and [ENTER] to return to the menu, or
• [ENTER] to return to the menu.
To Next Page
Loading...
