43
13. Start auto Disarm test
Use this function to start the disarm test.
To start the disarm test
1. Access menu option 13.
The display shows:
Disarm Test, NEXT For Untested
"0"-Cancel:
2. Press:
• [NEXT] to display the untested zones, or
• 0 and [ENTER] to cancel the arm test and move on to test completed/not completed
display.
3. If you have pressed [NEXT], the untested zones are displayed either one at a time or as a list:
Zones displayed one at a time Zones displayed as a list
For example:
Untested Disarm On 4. PIR In Office
NEXT or ENTER
For example:
Untested On 1, 2, 4.
Zone No:
4. For either display, you can now:
Option Action
Display the description of the selected zone (when displayed as
a list of numbers only)
Enter the zone number and press [ENTER]
Display the remaining untested zones (if any) Press [NEXT]
Move on to the Camera Test or Test Completed/Not Completed
display
Press [ENTER]
5. The display might shows information about cameras:
All Cameras Have Tested Successfully
Press ENTER
Press [ENTER] to return to the original option display.
Note that only cameras allocated to Area 1 are tested.
6. The testing automatically stops when:
• all zones that are programmed to be tested during disarm test have been tested, or
• the time allowed for the disarm test has expired.
The display then indicates if the test is completed or not.
To Next Page
Loading...
