45
14. Users
Important: The option "Change own PIN only" is available. When this option is enabled, refer to the procedure below. If the
option is disabled, refer to "Program Users".
To change own PIN code
1. Press [MENU*].
The display shows:
To Access Menu Enter Code
Code:
2. Enter your PIN code and press [ENTER].
The display shows:
0-Exit ENTER-Down *-Up
0-Exit, Menu:
3. Enter 14 and press [ENTER].
Depending on the security settings, the display shows either:
PIN Code:
Code: 1234
or
PIN Codes Cannot Be Displayed
Code:
If the code is visible, the user can change the code (The code will be displayed) and press Enter. The user can
change the code again, or press Enter to exit.
If the code is not visible, the user can change the code (The * will be displayed only.) and press Enter. The
following display will show:
Confirm PIN Code:
Code:
Enter PIN code again to confirm followed by Enter. The following display will show:
PIN Codes Cannot Be Displayed
Code:
The user can change the code again, or press Enter to exit.
To program users
Use this function to add, delete or create a user. Your system might have been set up to require two authorised
users to enter this menu.
The user programming includes a record of:
To Next Page
Loading...
