ATS Control Panel
Manager's manual
48
The display shows the user’s alarm group.
Example:
*-View, Alm Grp:12,Forman
Press ENTER
3. Press [ENTER].
The display shows the user's door group.
Example:
Door Group: 2
Press ENTER
4. Press [ENTER].
The display shows the user floor group.
Example:
Floor Group: 1
Press ENTER
5. Press [ENTER].
If your system is programmed to assign special User Flags to users, the display will now show the User Flags
in sequence. See the section "Create (and change) a user" for User Flag details.
The display shows the user name (if any and the user number is 200 or less).
Example:
Your Name is Ann Brown, (*)-End
Ann Brown
6. Press [ENTER]. The display shows the user PIN code.
Exceptions:
• PIN code view is disabled.
• There is no PIN code programmed.
• Depending on the memory mode, user numbers above 1000 will not be displayed.
Example:
Pin Code: 1234
Press ENTER
7. In case the special memory mode is selected, press [ENTER]. The display shows the user's Card Bits. This
is a representation of the code present in the card.
Example:
Card Bits: 27.0.0.4.210.0.2
Press ENTER
8. Press [ENTER] to return to step 1.
To Next Page
Loading...
