No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter Reference
64 Voltage Limit X
65 Control Board Over-temperature X X X
66 Heat sink Temperature Low X
67 Option Configuration has Changed X
68 Safe Stop Activated X E-07
69 Power card temperature X X
70 Illegal Drive configuration
71 PTC 1 safe stop X X X E-07
72 Dangerous failure X X X E-07
73 Safe stop auto restart X E-07
76 Power unit setup X
77 Reduced power mode X SP-59
78 Tracking error X H-24
79 Illegal PS config X X
80 Drive Restored to Default Value X
81 CSIV corrupt X
82 CSIV parameter error X
90 Feedback Monitor (X) (X) EC-61
91 Analog input 54 wrong settings X
92 No-Flow X X AP-2#
93 Dry Pump X X AP-2#
94 End of Curve X X AP-5#
95 Broken Belt X X AP-6#
96 Start Delayed X AP-7#
97 Stop Delayed X AP-7#
98 Clock Fault X K-7#
200 Fire mode (X) FB-00
201 Fire mode was active (X)
202 Fire mode limits exceeded (X)
243 Brake IGBT X X
244 Heatsink temperature X X X
245 Heatsink sensor X X
246 Power card supply X X
247 Power card temperature X X
248 Illegal PS config X X
250 New spare part X
251 New model number X X
Table 4.3: Alarm/Warning code list, continued..
(X) Dependent on parameter
LED indication
Warning yellow
Alarm flashing red
Trip locked yellow and red
High Power Service Manual for Unit Sizes 6x
52
4
To Next Page
Loading...
