GE Appliances Quickset III - Page 27

Cleaning the glass cooktop, consomemodels; GEAppliances.com
Clean your cooktop after
each spill. Use CERAHA
BRYTE®Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuseCERAIV]ABRVTE®Ceramic Cooktop
Cleaneron the glasscooktop. Other creams
may not be as effective.
Tomaintain and protect the surface of your
glasscooktop, follow these steps:
%
Beforeusing the cooktop for the
first time,clean itwith CERAIVlABRVTE®
Ceramic Cooktop Cleaner.This helps
protect the top and makescleanup easier.
[] Daily useof CERAMABRVTE®Ceramic
Cooktop Cleanerwill help keep the
cooktop lookingnew.
r-_ Shakethe cleaning cream well. Apply a
few drops of CERAHABRYTE®Ceramic
Cooktop Cleanerdirectly to the cooktop.
r_ use a paper towel or CERAIVlABRYTE®
CleaningPad for Ceramic Cooktops to
cleanthe entire cooktop surface.
Use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE:It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
_ i_ii i_il}iiiiii_i_:I iii_}i!_iiii_/
Use a CERAMABRYTE®Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
NOTE:DAMAGEto your glass surface may
occur if you use scrub pads other than those
recommended.
r_ Allow the cooktop to cool.
Spread a few drops of CERAiVlABRYTE®
Ceramic CooktopCleaneron the entire
burned residue area.
@
Using the included CERAMABRYTE®
Cleaning Padfor Ceramic Cooktops,rub
the residue area, applying pressure as
needed.
%
@
If any residue remains, repeat the steps
listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRVTE®
Ceramic Cooktop Cleanerand a paper
towel.
The CERAMABRYTE®Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
F71
Allow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove
the residue.
@
After scraping with the razor scraper,
spread a few drops of CERAMABRYTE®
CeramicCooktop Cleaneron the entire
burned residue area. Usethe CERAMA
BRVTE®Cleaning Padto remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRVTE®
CeramicCooktop Cleanerand a paper
towel.
27