Cleaning the glass cooktop, somemode/s
Metal Marks and Scratches
[Z] Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using the
CERAMABRYTE®Ceramic Cooktop Cleaner
with the CERAMABRYTE®CleaningPad
for Ceramic Cooktops.
[] If pots with a thin overlay of aluminum
or copper are allowed to boil dry, the
overlay may leave black discoloration
on the cooktop.
This should be removed immediately
before heating again or the
discoloration may be permanent.
NOTE'.Carefully check the bottom of pans
for roughness that would scratch the
cooktop.
Cooktop Seal
To clean the cooktop seal around the edges minutes, then wipe clean with nonabrasive
of the glass, lay a wet cloth on it for a few cleaners.
Glass surface--potential for permanent damage.
Our testing shows that
if you are cooking high
sugar mixtures such as
jelly or fudge and have
a spillover, it can cause
permanent damage to the
glass surface unless the
spillover is immediately
removed.
Damage from Sugary Spills and Melted Plastic
r_ Turn off all surface units. Remove hot
pans.
r2]
Wearing an oven mitt:
a. Use a single-edge razor blade scraper
(CERAIVlABRYTE®Ceramic Cooktop
Scraper) to move the spill to a cool
area on the cooktop.
r4] Don't use the surface units again until all
of the residue has been completely
removed.
NOT& If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced.
In this case, service will be necessary.
b. Remove the spill with paper towels.
r_ Any remaining spillover should be left until
the surface of the cooktop has cooled.
To Order Parts
To order CERArqABRYTE®Ceramic Cooktop
Cleanerand the cooktop scraper, please call
our toll-free number:
National Parts Center 800.626.2002
CERAMABRYTE®Ceramic
Cooktop Cleaner .......... #WX10X300
CERAMABRYTE®Ceramic
Cooktop Scraper .......... #WX10X0302
Kit ........................ #WB64XS027
(Kitincludes cream and cooktop scraper)
CERAMABRYTE®Cleaning Pads for
Ceramic Cooktops ...... #WX!0X350
28
To Next Page
Loading...
