149
Electromagnetic Compatibility
Changes or modifications to this system not expressly approved by GE can cause EMC issues with this or other equipment. This system is
designed and tested to comply with applicable regulation regarding EMC and must be installed and put into service according to the EMC
information stated in this section.
Guidance and manufacturer’s declaration – electromagnetic emissions
Guidance and manufacturer’s declaration – electromagnetic emissions
The monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the monitor
should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1 The monitor uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class A The monitor is suitable for use in all establishments other than domestic
establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Hermonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
