17
Symbols
− On the rear panel:
− Electric shock hazard. Do not open the front
or back cover. Servicing of the product
should be performed only by qualified
service personnel.
− For continued protection against fire hazard,
replace the fuse only with one of the same
type and rating.
− Disconnect from the power supply before
servicing.
− Do not use without manufacturer approved
mounting.
− On the hemo module this symbol indicates the
following warning: Protection against cardiac
defibrillator discharge is due in part to the
accessories for pulse oximetry (SpO2),
temperature (T) and invasive pressure (P)
measurement.
Consult operating instructions. / Operating
instructions.
Refer to instruction manual/booklet about
operation.
Electrostatic sensitive device. Connections should
not be made to this device unless ESD
precautionary procedures are followed.
Type BF (IEC 60601-1) protection against electric
shock. Isolated (floating) applied part suitable for
intentional external and internal application to the
patient, excluding direct cardiac application.
Type BF (IEC 60601-1) defibrillator-proof protection
against electric shock. Isolated (floating) applied
part suitable for intentional external and internal
application to the patient, excluding direct cardiac
application.
Type CF (IEC 60601-1) protection against electric
shock. Isolated (floating) applied part suitable for
intentional external and internal application to the
patient, including direct cardiac application.
Type CF (IEC 60601-1) defibrillator-proof protection
against electric shock. Isolated (floating) applied
part suitable for intentional external and internal
application to the patient including direct cardiac
application.
Audio alarms off indicator - Displays in the upper
left corner of the alarm area when physiological
audible alarms are turned off.
Alarm off indicator - Displays in the digit field and in
the Alarms Setup menu when physiological alarms
for this parameter are turned off.
To Next Page
Loading...
Need help?
General
