45
• NIBP cuff occlusion
•Check NIBP
• Weak pulsation
• Long measurement time
•NIBP manual
• NIBP cuff overpressure
• NIBP call service error
• Gas measurements removed
• Recorder module removed
• Entropy measurement removed
•Alarm volume changed
•Zero ICP separately
• Recorder system error
• Recorder cover open
• Recorder input voltage high
• Recorder input voltage low
• Recorder out of paper
• Recorder thermal array overheat
• No battery backup
Showing alarm history
1. Press the Pt.Data & Trends key.
2. Select Alarm History: a list of the last 20 alarms are displayed for
24 hours.
Latched Alarms
When alarms are latched, the alarm messages stay on the screen
even if the initial alarm condition goes away. You will also hear a
reminder beep every 10 seconds.
To clear the message field of the no longer active alarm messages
and to clear the beep:
•Press the Audio Pause key once, or
•Press
Alarm Reset key once.
See "Changing alarm options" in "Setting up the monitor before use"
chapter for how to latch alarms.
To Next Page
Loading...
