GE B20 - Recording with the recorder; Recording waveforms

56
Printing currently displayed screen contents
You can print currently displayed trend data.
To print trend data:
•Press the
Pt.Data & Trends key and select:
− Trends - Print Page
Recording with the recorder
Recording waveforms
You can record three waveforms to a local recorder, and two to four
waveforms to a network recorder:
1. Press the
Print/Record key, select Record Waveforms.
2. Setup the record settings:
• Waveform X: which waveform to be recorded.
• Start on Alarms: whether triggered by following alarms
reach the red level:
Asystole, Tachy, Brady, Art Sys/Dia/Mean high, Art Sys/Dia/
Mean low, V Fib, V Tach.
• Delay: record from 12 seconds prior the events, or record
from current time.
• Paper Speed: set up the paper speed to adjust the recorded
waveforms more clearly or more generally.
• Length: set up the length of the recording.
3. To start the recording, press the
Recorder Start/Stop key, or
Select Record Waveforms - Record to Local.
If the monitor is connected to the network, you can also use the
network recorder by selecting Record to Net. The network
recorder uses the settings of the Central.
4. To stop recording, press the
Recorder Start/Stop key, or
Select Stop Waveforms.