Revision D 170 Series Monitor 7-13
2003023-001
Strip Chart Recorder: Removing Unused Paper from the Recorder
Removing Unused Paper from the Recorder
If you need to remove unused paper from the recorder:
1. Slide the monitor forward so that the front is aligned with the edge of the cart or
table on which it stands.
2. Press on each side of the paper drawer to release the drawer latches.
3. Slide the paper drawer out toward you. The drawer should extend out over the
cart or table on which the monitor rests.
4. Reach underneath the paper drawer and locate the hole in the bottom of the
drawer. Use your finger to push up on the paper through this hole; then grasp
the paper with your other hand.
To Next Page
Loading...
Need help?
General
