GE CT-9800

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 3 Direction 18033
8-2-3
1. CTEX Release Notice
This release notice is called from DIR DZO at R level by entering TYPE 9800.RN return. The following example
print out will appear on the A/N CRT (if a line printer is available, enter PRINT 9800.RN return). 9800.RN
describes software changes that have been made and problems that still remain.
To determine what software changes have been made and what problems still remain in the software, the
9800.RN (release notice) is examined. To enter the release notice at R level from DIR DZ0, enter the following:
Use Control S and Control Q keys to stop and start display scroll.
R
TYPE 9800.RN
9800$SC.RN 9800/FC0 II PRODUCTION RELEASE NOTICE
18 November 86
LISTED BELOW (UNDER SUB-PRODUCTS) ARE: -
A) ENHANCEMENTS SINCE PREVIOUS PRODUCTION RELEASE
B) CHARACTERISTICS - TO BE IMPROVED IN LATER RELEASES
C) KNOWN PROBLEMS TO BE TEMPORARILY AVOIDED
***************************************************************************
HELP - REPORTS SYSTEM SOFTWARE REVISION AND A BRIEF DESCRIPTION OF
PROGRAMS AVAILABLE FROM R-LEVEL
---------------------------------------------------------------------------
UP - SETS UP AND CLEANS ALL NEEDED DIRECTORIES
----------------------------------------------------------
A) INITIALIZES THE ARRAY PROCESSOR
UPAP - INITIALIZES THE ARRAY PROCESSOR. DOES NOT SET UP AND CLEAN
ALL NEEDED DIRECTORS!
---------------------------------------------------------------------------
UPSYS - SETS UP AND CLEANS ALL NEEDED DIRECTORIES. DOES NOT
INITIALIZE THE AP!
---------------------------------------------------------------------------
STBUG - SERVICE TOOL FOR THE AP (NOT NORMALLY USED)
------------------------------------------------------------
STMON - SERVICE TOOL FOR THE AP (NOT NORMALLY USED)
------------------------------------------------------------
etc.