GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-33
The HELP Screen looks like this:
Enter command (? to see choices): H<CR>
OPERATIONS
----------
DEFAULTS - Whenever a question has a DEFAULT, the default value will be showing square brackets: []. NEW
LINE or CARRIAGE RETURN is the same as entering the default value.
EXITING from a question or menu that does NOT have a DEFAULT is accomplished by entering NEW LINE or
CARRIAGE RETURN. This lets you return to the higher level menu or question.
- If you respond to a question with “?”, you will b e shown the valid responses.
H - If you respond to a question with “H”, you will be given an explanation of the item. This should HELP you
determine your response.
EEPROM - At the beginning of the program the current values on the EEPROM are read from the controller.
When you are changing these values, only tables in CPU memory are affected. It is only when you select U on
the Main Command Menu that the EEPROM is actually updated.
Press New Line or Carriage Return to continue.<CR>
Enter command
(? to see choices): W<CR>
WHAT TO DO
----------
The GESCSI disk controller has been shipped from ZETACO with MOST configuration facts set to standard
recommended values. Usually you will choose to retain these values. However, the controller MUST be tailored
for the disk drive(s) which you will be using. Other CHANGE commands should be selected, if you wish to enter
your own values.
A reasonable sequence of events might be:
1. Select H on Command Menu. Read through HELP until you are comfortable.
2. Select L on Command Menu. This will let you see the values currently set on the controller.
3. Select N on Command Menu if you have a printer at device code 17. All questions and responses will then
be Logged to this printer.
4. Select D on Command Menu. A list of disk models will be displayed. Select your disk type. After entering all
your disks, enter EN to terminate disk entry.
5. Select L on Command Menu. This should show the results of what you just entered. Look at ALL the values.
Are they what you want? If so, go
Another page ([Y] OR N) Y<CR>
directly to step 8.
6. If you want to change just 1 or 2 items, select each of the items directly from the Command Menu.
7. If you want to change quite a few items, select A on the Command Menu. This will feed you thru all possible
items. For those you want to change, enter the new value. For those that are already set up correctly, enter
New Line or Carriage Return.
8. Select L on Command Menu. Take a final look at the values. If you did NOT turn Logging ON earlier, do so
now and then select L. This will provide you with a record of the values on the controller.
9. Select U on Command Menu. This will record the new values on the EEPROM.
10. Select Q on Command Menu. This terminates the program.
After the program has terminated, you may need to do some of the following:
Format or reformat the disk.
Initialize or re-initialize the disk.
Press New Line or Carriage Return to continue <CR>.
To Next Page
Loading...
