GE CT-9800 - Page 78

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 24 Direction 18000
4-3-34
The CHANGE ALL FACTS command should not be used except to reconfigure to a one or two drive
configuration. The information is already entered into the firmware. If you do reconfigure, you must also write the
changes to EEPROM to save them using the “U - Update EEPROM” command (this requires Switch 2 on the
controller board to be changed to the write enable position “UP” position). Be sure to set this switch back to the
“DOWN” or write protect position when finished.
The following is the configuration information for a CT Single ACE drive system:
Enter command (? to see choices): A<CR>
You must have a printer at device code 17 to log your dialogue to a printer.
Do you have such a printer (Y or [N]) ? N<CR>
Disk Selection
CT - Computed Tomography
MR - Magnetic Resonance
HTD - High Throughput Dynamic
UD - User-defined
ND - No Disk
Select Disk (or EN to END disk selection): CT<CR>
How many drives in this system (1-4) ? 1<CR> For 1 Disk system
Enter BMC priority (0=lowest, 7=highest; S280 and MV4000 0-3 only) [5 ] : <CR>
What is the throttle burst rate [32 ] ? <CR>
What is the throttle break count [4 ] ? <CR>
Current Configuration Facts:
----------------------------
Logical Logical Logical Logical
Unit 0 Unit 1 Unit 2 Unit 3
Heads 1 1 1 1
Sectors 128 128 128 128
Cylinders 4581 0 0 4
Formt’d megs 300 0 0 0
Logical blks 586062 0 0 267
To see the partitioning of a logical unit, enter the unit number:<CR>
C1 - CT using 1 ST34520N
Microcode on logical unit 0
BMC priority ........... 5
Throttle burst rate .... 32
Break count ............ 4
Enter command (? to see choices): ?U<CR>
Updating...Please wait
If you have changed something and do not wish to have the changes saved use the “[Q]uit” command as
follows:
Enter command (? to see choices): Q<CR>
EEPROM not updated! Do you really want to abandon these edits (Y/N) ? Y<CR>
After the program has terminated, you may need to do some of the following:
Format or reformat the disk.
Initialize or re-initialize the disk.
Do you want to configure another GESCSI controller (Y/[N]) ?N<CR>
M1 - MR using 1 ST34520N