GE CT-9800 - Page 81

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 24 Direction 18000
4-3-37
The following is the configuration information for a CT system with a single ST34520N drive:
Enter command (? to see choices): D<CR>
Disk Selection
CT - Computed Tomography C1 - CT using 1 ST34520N
HTD - High Throughput Dynamic
UD - User-defined
ND - No Disk
Select Disk (or EN to END disk selection): C1<CR>
..Disk type(s) accepted.
Enter command (? to see choices): L<CR>
Current Configuration Facts:
MR - Magnetic Resonance
M1 - MR using 1 ST34520N
----------------------------
Microcode on logical unit
BMC priority ........... 5
Throttle burst rate .... 32
Break count ............ 4
Logical Logical Logical Logical
Unit 0 Unit 1 Unit 2 Unit 3
Heads 1 1 1 1
Sectors 128 128 128 128
Cylinders 9161 0 0 0
Formt’d megs 600 0 0 0
Logical blks 1172316 0 0 792
To see the partitioning of a logical unit, enter the unit number: 0<CR>
0
Logical unit 0 :
Ending Blk # Offset SCSI Dev Unit #
Partition 0 1172507 0 0 0
To see the partitioning of a logical unit, enter the unit number: 1<CR>
Logical unit 1 :
Ending Blk # Offset SCSI Dev Unit #
Partition 0 0 0 0 0
To see the partitioning of a logical unit, enter the unit number: 2<CR>
Logical unit 2 :
Ending Blk # Offset SCSI Dev Unit #
Partition 0 0 0 0 0
To see the partitioning of a logical unit, enter the unit number: 3<CR>
Logical unit 3 :
Ending Blk # Offset SCSI Dev Unit #
Partition 0 983 1172508 0 0
To see the partitioning of a logical unit, enter the unit number: <CR>