GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 24 Direction 18000
4-3-45
ä 3-9 Final ACE Disk Check ACE Diagnostic Tape 46-266949G5
The configurator program is used to configure the ACE drives as a Single or a Dual drive system. It is important
that you do not change any of the other parameters. After using the Configurator program (“A” option), use the
“U” option to update the EEPROM (to save the new configuration). If you do not update the EEPROM, the new
configuration will not be saved and the previous configuration will be used.
File# Program
2 GESCSI CONFIGURATOR
3 GESCSI FORMATTER
4 GESCSI INITIALIZER
5 Previous “.SV” Files in RDOS DUMP Format
File Number? 2 <CR>
CFGESCSI-Configurator for GESCSI Controller
Revision Level = 4.02
Copyright 1987, ZETACO, Inc.
The purpose of the configurator program is to allow you to tailor the GESCS
controller to your particular environment. The GESCSI controller includes an
electrically erasable prom (EEPROM) which contains certain facts. This
program lets you list the current facts, modify those that you want changed,
and record the new facts onto the EEPROM.
The HELP command on the main menu provides information both on what to do and
how to do it. If this is the first time you have run this program, you might
want to start by selecting HELP.
You can get an explanation of any question the program asks, by responding to
that question with an H.
What is the present setting of the device code (in octal) ?24<CR>
Enter command (? to see choices): ?<CR>
COMMAND MENU
------------
A - Change All facts
B - BMC priority
D - Describe/Edit any of all Disk drives
F - Throttle burst rate
G - Break count
M - Unit for Microcode
H - HELP - Operations
W - HELP - What To Do
L - LIST all configuration facts
N - START logging to printer
O - STOP logging to printer
U - Update EEPROM
Q - Quit the
program
Enter command (? to see choices):
Copyright 1999, GE Co.
To Next Page
Loading...
