GE CT-9800

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-46
Configurator Program Continued:
The HELP Screen looks like this:
Enter command (? to see choices): H<CR>
OPERATIONS
DEFAULTS - Whenever a question has a DEFAULT, the default value will be shown in
square brackets: []. NEW LINE or CARRIAGE RETURN is the same as
entering the default value.
EXISTING from a question or menu that does NOT have a DEFAULT is accomplished by
entering NEW LINE or CARRIAGE RETURN. This lets you return to the
higher level menu or question.
- If you respond to a question with “?”, you will be shown the valid responses.
H - If you respond to a question with “H”, you will be given an explanation of the
item. This should HELP you determine your response.
EEPROM - At the beginning of the program the current values on the EEPROM are read
from the controller. When you are changing these values. Only tables in
CPU memory are affected. It is only when you select U on the Main Command
Menu that the EEPROM is actually updated.
Press New Line or Carriage Return to Continue.<CR>
Enter command (? to see choices): W<CR>
WHAT TO DO
The GESCSI disk controller has been shipped from ZETACO with MOST configuration
facts set to standard recommended values. Usually you will choose to retain these
values. However, the controller MUST be tailored for the disk drive(s) which you
will be using. Other CHANGE commands should be selected, if you wish to enter your
own values.
A reasonable sequence of events might be:
1. Select H on Command Menu. Read through HELP until you are comfortable.
2. Select L on Command Menu. This will let you see the values currently set on
the controller.
3. Select N on Command Menu if you have a printer at device code 17. All questions
and responses will then be Logged to this printer.
4. Select D on Command Menu. A list of disk models will be displayed. Select your
disk type. After entering all your disks, enter EN to terminate disk entry.
5. Select L on Command Menu. This should show the results of what you just
entered. Look at ALL the values. Are they what you want? If so, go
Another page ([Y] OR N) Y<CR>
directly to step 8
6. If you want to change just 1 or 2 items, select each of the items directly from
the Command Menu.
7. If you want to change quite a few items, select A on the Command Menu. This
will feed you thru all possible items. For those you want to change, enter the
new value. For those that are already set up correctly, enter New Line or
Carriage Return.
8. Select L on Command Menu. Take a final look at the values. If you did NOT turn
logging ON earlier, do so now and then select L. This will provide you with a
record of the values on the controller.
9. Select U on Command Menu. This will record the new values on the EEPROM.
10. Select Q on Command Menu. This terminates the program.
After the program has terminated, you may need to do some of the following:
Format or reformat the disk.
Initialize or re-initialize the disk.
Press New Line or Carriage Return to continue.<CR>