GE CT-9800

GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-53
The INITIALIZER Program
The initializer program is used to initialize the controller and disk drive(s) as well as load ACE microcode. The
Disk initializer program has four modules to it. 1) ZDKINIT (does all also) 2) ANALYZE DISK. 3) RELOCATE
BLOCKS 4) MICROCODE INSTALL ONLY. The ZDKINIT should normally be used as follows:
File# Program
2 GESCSI CONFIGUATOR
3 GESCSI FORMATTER
4 GESCSI INITIALIZER
5 Previous “.SV” Files in RDOS DUMP Format
File Number? 4<CR>
>>>
GESCSI Disk Formatter
Rev. 4.00
Copyright 1987, Zetaco Inc.
Command List
[E]nter a device [D]elete a device
[S]tart a device [H]alt a device
[R]estart the program [L]ist device status
[C]ommand list [P]rinter control
[F]lags [M]ode of display
[X]eq and error log [Q]uit
Enter a Command selection (C=Cmd List): E<CR>
Enter the device code [24 ]: <CR>
Start initialization of controller.
Micro-code rev #: 3.00
End initialization of controller.
Unit 0. is Ready: Select (YES.[NO]): YES<CR> NOTE: Use [Z] without selecting any
units to initialize the controller only.
Command choices:
[Z]DKINIT (ZDKINIT, INSTALL MICROCODE. INIT SOFT LOG)
[A]NALYZE DISK
[R]ELOCATE BLOCKS
[M]ICROCODE INSTALL ONLY
ENTER YOUR SELECTION [Z]: <CR>
UNIT 0. IS SELECTED NOTE: If other units are ready, do not select them for ZDKINIT.
UNIT 1. IS NOT READY
UNIT 2. IS NOT READY
UNIT 3. IS NOT READY
**** Note **** You must enter [S]tart in order to have the selected operation
actually take place.
Enter a Command Selection (C=Cmd List): S<CR>
Start all entered devices ([YES] NO): <CR>
Enter a Command Selection (C=Cmd List):
RUN TIME 0. HRS. 40 MINS. 3. SECS.
DEVICE CODE 24 UNIT NUMBER 0. DEVICE STATE: ** ACTIVE **
MODES: - INSTL MICROCODE - ZDKINIT
THIS UNIT IS COMPLETE WITH ITS ASSIGNED TASKS.
Enter a Command Selection (C=Cmd List): Q<CR>
This disk is now initialized and the microcode is loaded.