DigitalFlow™ GF868 Programming Manual (1-Channel) 15
Chapter 1. Programming Site Data
1.9.2 Setting Up Analog Outputs
The Model GF868 has two built-in analog outputs, which are assigned to Slot 0. Also, a variety of option cards may be
installed in the six expansion slots. See Chapter 1, Installation, of the Startup Guide for a complete description of the
available option cards.
This menu option is used to set up and/or scale the analog inputs and outputs. To accomplish this, complete the
following steps:
1. Use the and [ and the [F1]-[F4] keys to select the desired slot number. (Only those slots which contain an
option card will appear on the option bar.)
Note: If the number of a slot with an installed option card does not appear, the card may not have been initialized or
it may be defective. Call the factory for assistance.
Complete the following steps to set up the Slot x analog outputs:
1. Use the [F1]-[F4] keys to set up outputs A, B, C or D, respectively.
Note: The set up of output A is used as an example. Identical procedures would be used to set up the other outputs.
2. Press [F1] = OFF to disable output A and return to the previous prompt, or press [F2] = 0-20 m or [F3] = 4-20 m to
specify the desired range for output A.
3. Use the and [ and [F1]-[F4] keys to specify the desired Output Measurement parameter (see Figure 11 on
page 87).
4. Enter the Zero value for the low end of the chosen output range. Press [ENT].
5. Enter the Full value for the high end of the chosen output range. Press [ENT].
6. Use the [F1]-[F4] keys to set up another output or press [EXIT] to select another slot for setup.
For instructions on setting up additional inputs and/or outputs proceed to the appropriate section. Otherwise, press
[EXIT] to return to the main I/O menu prompt.
To Next Page
Loading...
Need help?
General
