K0430 Issue No. 4 22
• Min/Max Process Function
To set-up an input display to show min/max and present input reading, enable
MIN/MAX from the process menu and press F1 (SETTINGS) to provide RESET
function. The display now shows the max/min values as follows:
Reset Max/Min display at any time by pressing the
F1 key.
To quit max/min, press INPUT, select MAX/MIN
from process menu and switch the function off.
• Filter Process Function
To apply the low pass filter to a selected input, enable FILTER from the process
menu and press F1 (SETTINGS) to provide access to the filter parameters. Two
settings are required, Time to Settle and Band.
To examine the current filter settings and exit without change, press the EXIT key.
The set-up procedure is as follows:
Advanced Task Process Functions
To Next Page
Loading...
