CHAPTER 5: OVERVIEW
28
EPM 5000 series Advanced Power Meters GE Multilin
5.1: Accessing the Power Functions
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWHKVAH
AC VOLTS
AC AMPS
POWER
NCBA
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
AMPS
POWER
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWH
KVAH
AC VOLTS
AC AMPS
POWER
NC
B
A
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
AMPS
POWER
Step 1:
a. Press POWER to select the power category.
!The display blanks and all annunciators in the
power section glow, confirming selection.
Step 2:
a. Press PHASE/NEXT for the desired power function.
!The functions are accessed in a clockwise sequence.
Note: For KWH readings: The first digit on the left of the KWH counter will blank out on the display
when rollover at 199999 KWH occurs. The actual value of the first digit can only be viewed
through digital communications. Or, reset the KWH counter to zero to avoid confusion.
5.2: Accessing Voltage and Current Phases
The EPM5300P displays four current measurements (phases A, B, C, and Neutral) and six voltage
measurements (phase-to-phase: A-B, B-C, C-A and phase-to-neutral: A-N, B-N, C-N).
MAX/MIN
LIMITS
KVAR
PF
KW
KV
FREQ
KWHKVAH
AC VOLTS
AC AMPS
POWER
NC
B
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
OLTS
AMPS
POWER
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWH
KVAH
AC VOLTS
AC AMPS
POWER
NC
B
A
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
AMPS
POWER
Step 1:
a. To select the Amps (or Volts) category, press
AMPS (or VOLTS).
! The display blanks and all annunciators in the
section glow, confirming selection.
Step 2:
a. Press PHASE/NEXT for the desired phase.
5.3: Accessing %THD Functions
Harmonic Measurement readings are available on the EPM 5300P meter. The EPM 5300P displays 6
parameters of total harmonic distortion. It measures harmonic waveforms and %THD for voltage phases
A-N, B-N and C-N, and current phases A, B and C. Measurement capability reaches the 31
st
harmonic
order. All readings are faceplate accessible.
To Next Page
Loading...
