GE EPM 5300 User Manual

GE Multilin EPM 5000 series Advanced Power Meters iv
C
HAPTER 10: PROGRAMMING GROUP 1:
VOLTAGE, AMP AND WATT
SCALE SETTINGS.........55
10.1: Group 1, Function 0—Full
Scale Voltage Settings, Scale
Factor & Decimal Point
Placement ...............................55
10.2: Group 1, Function 1—
Amperage Full Scale...............58
10.3: Group 1, Function 2—Scale
Selection and Decimal
Placement for Watts................59
C
HAPTER 11: PROGRAMMING GROUP 2:
METER CALIBRATION .......63
11.1: Calibration Requirements .......63
11.2: Group 2, Functions 0–8—
High End Calibration of Voltage
Channels, High and Low End
Calibration of Amperage
Channels.................................64
C
HAPTER 12: GROUPS 4, 5 AND 6: SET
L
IMITS AND RELAYS ...67
12.1: Trip Relay................................67
12.2: Time Delays & Relay Mode ....67
12.3: Group 4, Functions 0–3—
LM1/LM2 Set Limits ................68
12.4: Group 5, Functions 0–7—
LM1/LM2 Set Limits ................69
12.5: Group 6, Functions 0–5—
LM1/LM2 Set Limits and
Relay Triggers for Over/Under
%THD Conditions ...................72
12.6: Limits or Relays Programming
Procedure ...............................72
C
HAPTER 13: PHASE REVERSAL
AND PHASE IMBALANCE
SET LIMITS/RELAYS..........75
13.1: Phase Reversal and Phase
Imbalance ...............................75
13.2: Trip Relay................................75
13.3: Group 7, Function 0—Voltage
Phase Reversal Detection ......76
13.4: Group 7, Function 1—
Percentage Voltage Phase
Imbalance ...............................77
C
HAPTER 14: EXITING THE PROGRAMMING
MODE ............................. 79
C
HAPTER 15: PROGRAMMING QUICK
REFERENCE………………81
15.1: Entering the Programming
Mode ...................................... 81
15.2: Data Entry Sequence ............. 81
15.3: Programming Groups ............. 81
15.4: Group 0: Global Setup............ 82
15.5: Group 1: Full Scale Setup ...... 83
15.6: Group 2 Calibration ................ 83
15.7: Group 3 Calibration Ratios ..... 83
15.8: Group 4: Volt/Current Limits... 83
15.9: Group 5: Power Function Limits
......................................................... 84
15.10: Group 6: THD Limits............. 84
15.11: Group 7 Imbalance/Reversal
Limits .................................... 84
15.12: Group 8: DC Output
Calibration ............................ 84
CHAPTER 16: ETHERNET OPTION ......... 87
16.1: Ethernet Module
............................................... 87
16.2: Ethernet Option Setup ............ 88
16.3: Default IP Address…………….89
16.4: AutoIP…………………………..89
16.5: Setting the IP Address………..89
16.6: Network Configuration……….. 90
16.7: Configuration Parameters…….91

GE EPM 5300 Specifications

General

Brand	GE
Model	EPM 5300
Category	Measuring Instruments
Language	English