CHAPTER 15: PROGRAMMING QUICK REFERENCE
86
EPM 5000 series Advanced Power Meters GE Multilin
15.4: Group 0—Global Meter Setup
00. Interval.
01. Meter Address for Communication.
02. Baud Rate for Communication.
03. System Configuration Switch Packs.
030. Reserved Switches.
031.
A. Blank Non Significant Leading Zeros
B. Reset Protection
C. Phase Reversal Rotation Selection
D. Open Delta Configuration
032.
A. Instantaneous/Average Limit
B. Power Factor Polarity
C. Modbus Options
D. Protocol Selection
033.
A. Computer Control Relay 1
B. Computer Control Relay 2
C. Communication Selection
D. DC-Output/Print Control
04. Relay 1 Programming
04P.
A. Imb/Rev Selection
B. And/or Logic
C & D. Relay Control Selection
040. ON to OFF delay time
041. OFF to ON delay time
05. Relay 2 Programming 05P.
A. Imb/Rev Selection
B. Reserved
C. & D. Relay Mode Selection
050. ON to OFF delay time
051. OFF to ON delay time
To Next Page
Loading...
Need help?
General
