GE G60 - Page 775

GE Multilin G60 Generator Protection System v
INDEX
IEC 61850 PROTOCOL
device ID..................................................................... 5-299
DNA2 assignments ...................................................... 5-301
error messages ............................................................. 7-10
FILE TRANSFER .............................................................C-2
Modbus registers..............B-56, B-57, B-58, B-59, B-60, B-71
remote inputs .............................................................. 5-299
settings ......................................................................... 5-41
UserSt-1 bit pair .......................................................... 5-301
IEC CURVES ................................................................. 5-181
IED SETUP........................................................................ 1-6
IEEE C37.94 COMMUNICATIONS ................... 3-39, 3-41, 3-45
IEEE CURVES ............................................................... 5-180
IMPORTANT CONCEPTS................................................... 1-5
IN SERVICE INDICATOR .......................................... 1-19, 7-7
INCIPIENT CABLE FAULT DETECTOR
Modbus registers...........................................................B-36
INCOMPATIBLE HARDWARE ERROR................................ 7-7
INPUTS
AC current.............................................................2-22, 5-93
AC voltage ............................................................2-22, 5-94
contact inputs........................................... 2-22, 5-292, 5-322
DCmA inputs .........................................................2-22, 3-23
direct inputs .................................................................. 2-23
IRIG-B ..................................................................2-23, 3-28
remote inputs .................................2-23, 5-298, 5-299, 5-300
RTD inputs ............................................................2-22, 3-23
virtual ......................................................................... 5-294
INSPECTION CHECKLIST ................................................. 1-2
INSTALLATION
communications ............................................................ 3-26
CT inputs ..............................................................3-12, 3-13
RS485........................................................................... 3-27
settings ......................................................................... 5-91
INSTANTANEOUS OVERCURRENT
see PHASE, GROUND, and NEUTRAL IOC entries
INTER-RELAY COMMUNICATIONS.................................. 2-27
INTRODUCTION ................................................................ 1-3
INVERSE TIME UNDERVOLTAGE.................................. 5-223
IOC
see PHASE, GROUND, and NEUTRAL IOC entries
IP ADDRESS ...........................................................5-30, 5-31
IRIG-B
connection .................................................................... 3-28
error messages ........................................................ 7-8, 7-9
specifications ................................................................ 2-23
ISO-9000 REGISTRATION ............................................... 2-30
K
KEYPAD..................................................................1-19, 4-22
L
LAMPTEST........................................................................ 7-3
LANGUAGE ..................................................................... 5-24
LASER MODULE ............................................................. 3-31
LATCHING OUTPUTS
application example...........................................5-296, 5-297
error messages ............................................................... 7-9
settings ....................................................................... 5-295
specifications ................................................................ 2-24
LED INDICATORS ........................ 4-14, 4-15, 4-16, 4-17, 5-71
LED TEST
FlexLogic operand .......................................................5-145
settings .........................................................................5-69
specifications.................................................................2-20
LINK POWER BUDGET ....................................................2-27
LOCAL SETTING AUTHORIZATION....................................4-2
LOGIC GATES ............................................................... 5-147
LOGS, SYSTEM ...............................................................5-23
LOSS OF EXCITATION
characteristics ............................................................. 5-234
FlexLogic operands...................................................... 5-140
logic ............................................................................ 5-235
Modbus registers .......................................................... B-39
settings ............................................................ 5-233, 5-234
specifications.................................................................2-19
LOST PASSWORD .............................................................5-8
M
MAINTENANCE
alert to replace battery .....................................................7-8
battery...........................................................................11-3
module replacement................................................ 3-6, 11-1
MAINTENANCE COMMANDS .............................................7-3
MANUFACTURING DATE .................................................6-30
MAXIMUM CT/VT WIRE SIZE ...........................................3-12
MEMORY MAP DATA FORMATS ..................................... B-77
MEMORY VOLTAGE LOGIC ........................................... 5-161
MENU HIERARCHY................................................. 1-19, 4-25
MENU NAVIGATION................................................ 1-19, 4-23
METERING
conventions .......................................................... 6-13, 6-14
current...........................................................................2-21
frequency ......................................................................2-22
harmonics......................................................................2-22
power ............................................................................2-21
THD ..............................................................................2-22
voltage ..........................................................................2-21
METERING CONVENTIONS .............................................6-14
MHO DISTANCE CHARACTERISTIC .............................. 5-162
MODBUS
data logger .............................................................. B-7, B-8
event recorder ................................................................ B-8
exception responses ....................................................... B-6
execute operation ........................................................... B-5
flex state parameters .....................................................5-80
function code 03/04h....................................................... B-4
function code 05h ........................................................... B-5
function code 06h ........................................................... B-5
function code 10h ........................................................... B-6
introduction .................................................................... B-1
memory map data formats ............................................. B-77
obtaining files ................................................................. B-7
oscillography .................................................................. B-7
read/write settings/actual values...................................... B-4
settings ................................................................ 5-35, 5-59
store multiple settings ..................................................... B-6
store single setting.......................................................... B-5
supported function codes ................................................ B-4
user map .....................................................5-59, B-11, B-32
MODEL INFORMATION ....................................................6-30
MODIFICATION FILE NUMBER ........................................6-30
MODULE FAILURE ERROR ................................................7-7