– 43 –
MWFP Filter Cartridge Removal
• Slowly turn the lter to the left. Do not pull
down on the cartridge.
MWFP Filter Cartridge Installation
1. Fill the replacement cartridge with water
from the tap to allow for better ow from the
dispenser immediately after installation.
2. Line up the arrow on the cartridge and the
manifold. Place the top of the new cartridge
up inside the holder. Do not push it up into
the manifold.
XWF Filter Cartridge Removal
1. Open the lter cartridge housing by squeezing
two front tabs and gently pull the cover down.
2. Rotate the lter down.
3. Grasp the lter and slowly turn it
counterclockwise about a 1/4 turn. The lter
should automatically release itself when it has
been rotated far enough to the left.
Filter Cartridge Installation
3. Slowly turn it to the
right until the lter
cartridge stops. DO NOT
OVERTIGHTEN. The
cartridge will move about a
1/2 turn.
4. Run water from the dispenser for 1-1/2
gallons (about three minutes) to clear the
system and prevent sputtering.
5. Press and hold the Water Filter pad on the
dispenser board for three seconds.
NOTE: Remove the water lter to immediately
stop any water leak from the Icemaker/Dispenser
system. The water lter manifold acts as a cut-o
valve when the lter is removed and will prevent
further leaking.
Water Filter (MFWP) Water Filter (XWP)
1. Follow XWF Filter
Cartridge Removal
steps.
2. Line the ports on the
lter with the ports of
the manifold, and gently
insert the lter.
3. Slowly turn the lter
to the right until it
stops. DO NOT
OVERTIGHTEN. The
lter will move about a
1/4 turn (90 degrees),
until the arrow on the
lter aligns with the
arrow on the manifold.
4. Slowly push the lter up
into the clips. Close the
lter cover by pushing
upwards on the cover
until the tabs lock into
place.
5. Run water from the dispenser for 2 gallons
(about ve minutes) to clear the system and
prevent sputtering. If water is not owing,
check to make sure the lter has been fully
rotated to the right.
6. Press and hold the Water Filter pad on the
dispenser board for three seconds.
NOTE: Remove the water lter to immediately
stop any water leak from the Icemaker/Dispenser
system. The water lter manifold acts as a cut-o
valve when the lter is removed and will prevent
further leaking.
To Next Page
Loading...
Need help?
General
