INSTALLATION
38 / 146 OI 250 (EN) REV7 /REV7
• To lift the operating mechanism, use two slings and the locating
pins on the side surfaces of the mechanism.
• Loop one end of each sling under two locating pins and hook the
other end in the crane hook.
• Lift the operating mechanism (1) and position it in front of the
lattice support.
• Lubricate four bolts (14) as described in L1 and insert them along
with washers (12) and (15) into the mechanism from the lattice
support side. Make sure that washer (15) is seated between the
support and the mechanism.
• Screw nuts (13) and washers (12) loosely on the four bolts inside
the mechanism.
• Push the mechanism as far to the left as possible in the direction
of pole B and tighten the four nuts.
Tighten to a torque of 196 Nm.
• Replace the spring guard plate (8) and fasten it to the mechanism
using two screws (7). Tighten to a torque of 23 Nm.
1 Operating mechanism 1x
10 Lattice support 1x
12 Washer, 16 A2 8x
13 Hexagon nut, M16 A2-70 4x
14 Hexagon bolt, M16x90 8.8 TZN 4x
15 Washer 16 TZNO / t=8mm 4x
To Next Page
Loading...
