GE GL 311 F3/4031 P/VE - Connecting the Drive Rod to the Drive Lever

INSTALLATION
42 / 146 OI 250 (EN) REV7 /REV7
6.9.3 Connecting the Drive Rod to the Drive Lever
• Lubricate the flanged coupling pin (14) as per L2.
• Connect the drive rod (5) and the drive lever (4) using the flanged
coupling pin (14), while maintaining the installation position of the
drive rod. The side of the drive rod with the hexagon nut faces
Pole B.
• Apply locking adhesive S1 to the screw (13).
• Lock the flanged coupling pin (14) using the locking sleeve (11),
washer (12) and screw (13). Tighten to a torque of 7Nm.
2 Pole B 1x
4 Drive lever 1x
5 Drive rod 1x
11 Locking sleeve 1x
12 Washer, 6 A2 1x
13 Hexagon screw, M6x16 A2-70 1x
14 Flanged coupling pin, 16x68 1x
2
4
5
11
12
13
14
BA-P-B-ANTR-HEB