iBox/iBox Kit
Installation and Maintenance Guide
GE Grid Solutions
994-0047-5.10-4 GE Information
Configuring iBox Device Properties - LAN, continued
Procedure:
Configuring
Device
Properties
- LAN
[continued]
Step Action
6
Click the Processor tab.
7
On the Memory Model tab, ensure that Derive From iBox Hardware
Setting is selected.
8
Confirm the settings are as shown above, and modify them if they are not.
9
Click the LAN Settings tab, and then click the General tab.
10
Confirm the settings are as shown above, and modify them if they are not.
11
Click the LAN Specific tab:
12
Enter the Host Address.
Note: The Host Address is set to [(PPP IP Address of the Ethernet
Module) + 1]. The iBox and Ethernet Module PPP IP addresses
are related, as outlined in “IP Addressing” on page 81.
Note: Do not change the Ethernet Address settings.
13
Click OK to save.
Next Step
The next step is:
• Configuring the iBox PPP Driver on page 103
To Next Page
Loading...
Need help?
General
