GE iBox User Manual

GE Grid Solutions
iBox/iBox Kit
Installation and Maintenance Guide
GE Information
994-0047-5.10-4
109
Configuring the Ethernet Module
Introduction
The following procedure describes the configuration of the Digi One IAP Ethernet
Module.
Procedure:
Configuring
the Digi One
IAP
You need to set the Digi One Ethernet and PPP IP addresses. Refer to “IP
Addressing” on page 81 for an explanation. You also need to change the Digi One
root password.
Step Action
Connecting to the Digi One
1 Connect a PC to the Digi One IAP’s RJ45 connector either directly, as
shown below:
iBOX Kit
Digi One
IAP
PC running
a Web browser, IP address in
the same subnet as the
Ethernet Module
Crossover Ethernet
Cable
or through the network:
iBOX Kit
Digi One
IAP
PC running
a Web browser, IP address in
the same subnet as the
Ethernet Module
Straight-through
Ethernet Cable
LAN
Continued on next page

GE iBox Specifications

General

Brand	GE
Model	iBox
Category	Controller
Language	English