GE JGS968 - Clock, Timer, and Lockout Features; Setting Clock, Timer, and Lockout

ge.com (U.S.)
Using the clock, timer andcontrol lockout, wvvw.GEAppliances.ca(Canada)
I¸
Make sure the clock is set to the
correct time of da_
ToSet the Clock
The clock must be set to tile correct time
of (la_ fin" tile automatic oxen tinting
flmctions to work properl). Tile time of
da) cannot be changed duYing a timed
baking or self=cleaning cycle.
[] Touch tile CLOCK pad.
[] Touch tile number pads.
[] Touch the START pad.
Thetimer is a mflTutetimer onI,A
Thetimer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59mflTutes.
ToSet the Timer
[]
[]
Touch tile KITCHENTIMER
ON/OFF pad.
Touch tile nmnber pads tmfil tile
_lIIlO/lnt of time yo/] want shows
in tile display: For example, to set
2 horns and 45 minutes, touch 2, 4
and 5 in that order: If you make a
mistake touch tile KITCHENTIMER
ON/OFFpad and begin again.
[] Touch tile STARTpad.
AftertouchingtheSTARTpad,SETdisappears,
thistellsyouthetl_neis countingdown,although
thedisplaydoesnot changeuntiloneminutehas
passedSecondswi//notbeshownb thedisplay
untilthe/astmbute iscountingdown.
[] _'_ hen tile timer reaches :00, tile
control will beep 3 times fbllowed
by one beep eve_ T 6 seconds tmtil
tile KITCHENTIMERON/OFFpad
is touched.
The6-second tone can be cance/ed by following
thestepsb theSpecialfeaturesofyouroven
controlsectionunderTonesat theEndofa
TimedCycle.
ToReset the Timer
If tile display is st.ill showing tile time
remaining, you may change it by
touching tile KITCHEN TIMER ON/OFF pad,
then touch the number pads tmtil the
time w)u want appea_ in tile displa>
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching tile KITCHEN TIMER ON/OFFpad
and then touching tile number pads to
entei" tile new tiI/le VO/I W;lIlt,
ToCancel the Timer
Touch tile KITCHENTIMERON/OFF
pad twice.
LOCK/UNLOCKHOLD3 SECONDS
Control Lockout
Yourcontrolwill allowyoutolockout thetouch
padsso theycannotbeactivatedwhenpressed
To lock/tmhwk tile controls:
[] Touch tile 9 and Opads at tile same
time fin 3 seconds, tmfil tile displa)
shmvsLOCON.
[] To unlock tile control, touch tile 9
and 0pads at tile same time for 3
seconds, tin61 the display shows
LOC OFF.
When this teatm'e is on and tile touch
pads are touched, tile control will beep
and the display will show LOCON.
Thecontrollockoutmodeaffectsall touch
pads.Notouchpadswi// workwhenthis
featureis activated
Theadjustmentwiiiberetalhedlnmemory
afterapowerfailure.
15