ge.com(U.S.)
www.GEAppliances.ca(Canada)
Possible Causes
Control signals after You forgot to enter a
entering cooking time bake temperature or
or start time cleaning time.
What To Do
• Touch the BAKE pad and desired temperature or
the SELF CLEAN LO/STD pad and desired clean time.
Display goes blank A fuse in your home may • Replace tile fl/se or reset tile circuit breaker:
be blown or the circuit
breaker tripped.
The clock is in the • See tile Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset tile clock.
Unable to get the Oven control pads were • Tile BROIL HI/LO and BAKE pads must be touched at
displayto show "SF" not touched properly, tile same time and held fm 3 seconds.
"Probe" appears in This is reminding you to • Enter a l)robe tenqaerature.
the display enter a probe temperature
after plugging ha the probe.
Power outage, Power outage or surge. • Reset tile clock. ]f the oven was in use you must reset
clock flashes it by touching the CLEAR/OFFpad, setting tile clock
and resetting any cooking flu]orion.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible stemn will increase.
"Burning" or "oily"
odoremittingfrom
the vent
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time, minimum of 3 hem's. See the Using the self-cleaning
o_ei] sectioi].
Strongodor
An odor from the insulation • This is tempora_ T.
around the inside of the oven
is normal for the first few times
the oven is used.
Fannoise
A cooling fan or a convection
fan (depending on the
function you axe using) ]nay
automatically turn on mad off.
• This is normal. The cooling tim will turn off and
on to cool internal parts. It may Hu] after the oven is
turI]ed OFF. The convection thn will cycle on and off
until the flu]ction is over or the door is opened.
4/
To Next Page
Loading...
