Installation Instructions
PLACEMENT OF THE MOUNTING PLATE
[_ REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
[] Remove the installation instructions, filters, glass
tray; and the small hardu-are bag. Do not remove
the Styrofoam protecting the front of the oven.
[] Fold back all 4 carton flaps fiflly against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should he resting in
the Svyrofoam.
Styrofoam\
[]Pull the carton up and off the oven.
[] Remove and properly discard plastic bags.
Mounting
Plate
[] Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting. You may" discard these screws.
I-_ FINDING THE WALL STUDS
[] Find the studs, using one of the following
methods:
A. Stud finder - a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
[] After locating the stud(s), find the center by"
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" or 24" from this mark.
[]Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
8
To Next Page
Loading...
