MA-003 – MULTITRANS User Guide – Rev 3.0 18-Jan-16 Page 13 of 30
6 LCD PANEL
The LCD panel is located on the inner cover and is visible when the door is open as shown
in Figure 6—1.
Figure 6—1: Inside view
During an analysis, the LCD panel shows the serial number of the product and the
operational state. The last measurement results with date and time stamps can be
obtained by using the black scroll buttons to page up or down through the details (see
Section 6.1 for examples). By default, automatic paging is turned off.
6.1 LCD Notifications
The section outlines some examples of the notices and data pages rendered on the LCD
panel for a standard environment using factory settings. It illustrates typical information
that a user is likely to see during normal operation. This can vary depending on the
operational environment, firmware version and how the product is configured.
6.1.1 Startup
6.1.1.1 Boot
The Boot notice displays after power up or reset and progresses through a code checking
sequence as shown in Figure 6—2. If boot problems occur, the product raises an error.
Contact the Customer Service Centre.
To Next Page
Loading...
Need help?
General
