Figure 6—9: Stop a measurement
6.1.2.4 Measurement Data
Use the black scroll buttons at any time to page through the notices and see the
measurement data. For example, data for Source 1 is shown in Figure 6—10. Similar
pages display for each oil source in turn (Sources 2 and 3). The product can also be
configured to automatically page through the results of the last analysis for each oil
source. Note: If nitrogen measurement is not enabled, the nitrogen and total gas concentration is omitted.
Figure 6—10: Measurement data
6.1.3 Manual Oil Sampling
Use the white Manual Sample button to initiate the manual oil sampling process. If the
white Manual Sample button is pressed during a measurement, the notice shown in
Figure 6—11 displays.
Figure 6—11: Measurement in progress
Wait until the current measurement process is complete or stop the current
measurement process (See Section 6.1.2.3). The system returns to Standby as shown in
Figure 6—12.
Figure 6—12: Standby mode
To Next Page
Loading...
