Chapter 3: Configuration and commissioning
Kilsen KFP-CF Series Installation Manual 35
Zone delay
Use this menu to configure zone delays, on or off, for each zone in your fire alarm
system. The default setting is ON.
To configure the zone delay:
1. Set the display as shown below, and then press Enter.
2. Select the zone (for example, zone 1), and then press Enter.
The Zone alarm LED flashes quickly to indicate that the corresponding zone
configuration menu is active.
3. Select a value using the value selection buttons (2 and 4).
4. Press Enter.
5. Save your changes.
The available settings for this feature are shown below.
Display Description
Configured delays are allowed in the corresponding zone.
Configured delays are not allowed in the corresponding
zone
To Next Page
Loading...
Need help?
General
