Chapter 4: Maintenance
46 Kilsen KFP-CF Series Installation Manual
Fire alarm system maintenance
Perform the following maintenance tasks to ensure that the fire alarm system works
correctly and complies with all required European regulations.
Caution: Before performing any tests, ensure that fire routing (if configured) is
disabled or that the fire brigade has been notified.
Daily maintenance
Check that the control panel is in standby. If it is not, investigate all system events
and/or fix any reported faults.
Weekly maintenance
Activate an alarm from at least one detector or manual call point in your fire alarm
system and verify that the control panel responds correctly to the alarm. If it does
not, investigate all system events and/or fix any reported faults.
Caution: Perform this test from a different detector or manual call point each time.
Quarterly maintenance
Test at least one device per zone and verify that the control panel responds to all
fault and alarm events. The control panel power supply and battery voltage should be
checked. Batteries with low voltage must be replaced (for more information see
“Battery maintenance” on page 47).
Annual maintenance
Test all system devices and verify that the control panel responds to all fault and
alarm events. All electrical connections must be visually inspected to make sure that
they are securely fastened, that they have not been damaged, and that they are
appropriately protected.
Cleaning the control panel
Keep the outside and inside of the control panel clean. Carry out periodic cleaning
using a damp cloth for the outside. Do not use products containing solvents to clean
the control panel. Do not clean the inside of the cabinet with liquid products.
To Next Page
Loading...
Need help?
General
