Chapter 3: Configuration and commissioning
40 Kilsen KFP-CF Series Installation Manual
Expansion module function and delay configuration
Once an expansion module is installed and added to the control panel configuration,
the following additional configuration options appear on the basic and advanced
configuration menus.
Note: These configuration options are repeated for each of the installed expansion
modules (A, B, C, and D).
Table 9: Expansion module A configuration options
Display Description Value
Module A function 00 to 92
Module A output 1 delay 00 to 10 minutes
Module A output 2 delay 00 to 10 minutes
Module A output 3 delay 00 to 10 minutes
Module A output 4 delay 00 to 10 minutes
Expansion module function
Use this menu to configure the expansion module function. The default value is 00.
For available presets, see Appendix A “Configuration presets” on page 59.
To configure the expansion module function:
1. Set the display as shown below, and then press Enter.
The Expansion I/O Fault/Disabled LED on the control panel interface and the ON
LED on the expansion module flashes quickly to indicate that the module function
configuration menu is active.
2. Select a value from 00 to 92 using the value selection buttons (2 and 4).
See Appendix A “Configuration presets” on page 59.
3. Press Enter.
4. Save your changes.
To Next Page
Loading...
Need help?
General
