GE M60 UR Series - Page 564

B-90 M60 Motor Protection System GE Multilin
B.4 MEMORY MAPPING APPENDIX B
B
F552
ENUMERATION: RTD INPUT OPEN
F600
UR_UINT16: FLEXANALOG PARAMETER
Corresponds to the Modbus address of the value used when this
parameter is selected. Only certain values may be used as Flex-
Analogs (basically all metering quantities used in protection).
F601
ENUMERATION: COM2 PORT USAGE
F602
ENUMERATION: RRTD BAUD RATE
F603
ENUMERATION: RRTD TRIP VOTING
F605
ENUMERATION: REMOTE DOUBLE-POINT STATUS INPUT
STATUS
F606
ENUMERATION: REMOTE DOUBLE-POINT STATUS INPUT
F611
ENUMERATION: GOOSE RETRANSMISSION SCHEME
F612
UR_UINT16: FLEXINTEGER PARAMETER
This 16-bit value corresponds to the Modbus address of the
selected FlexInteger parameter. Only certain values may be used
as FlexIntegers.
F615
ENUMERATION: IEC 61850 REPORT DATASET ITEMS
11 RTD Input 10
12 RTD Input 11
13 RTD Input 12
Enumeration RTD open
0None
1Alarm
2Block
Enumeration COM2 port usage
0 RS485
1RRTD
2 GPM-F
3 RRTD and GPM-F
Enumeration RRTD baud rate
0 1200 bps
1 2400 bps
2 4800 bps
3 9600 bps
4 19200 bps
Enumeration RRTD trip voting
0None
1Group
2 Remote RTD 1
3 Remote RTD 2
4 Remote RTD 3
5 Remote RTD 4
6 Remote RTD 5
7 Remote RTD 6
8 Remote RTD 7
9 Remote RTD 8
10 Remote RTD 9
11 Remote RTD 10
Enumeration RTD trip voting
12 Remote RTD 11
13 Remote RTD 12
Enumeration Remote DPS input status
0 Intermediate
1Off
2On
3Bad
Enumeration Remote double-point status input
0None
1 Remote input 1
2 Remote input 2
3 Remote input 3

64 Remote input 64
Enumeration Configurable GOOSE retransmission scheme
0 Heartbeat
1 Aggressive
2Medium
3 Relaxed
Enumeration IEC 61850 report dataset items
0None
1 PDIF1.ST.Str.general
2 PDIF1.ST.Op.general
3 PDIF2.ST.Str.general
4 PDIF2.ST.Op.general
5 PDIF3.ST.Str.general
6 PDIF3.ST.Op.general
7 PDIF4.ST.Str.general
8 PDIF4.ST.Op.general
9 PDIS1.ST.Str.general
Enumeration RRTD trip voting