GE MI-869 - Results Window

3–44 869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
SOFTWARE INTERFACE CHAPTER 3: INTERFACES
Figure 3-15: Conversion Report in Offline Window
CAUTION:
For future reference, the user is advised to take a printout of the conversion report
immediately after the conversion. All conversion reports are removed and become
inaccessible if the user removes or modifies the converted file from the 8 Series Setup
Software.
Results Window The following figure shows an example conversion summary results window.
Figure 3-16: Results Window
The results window has the following columns:
• Name:
the same tree structure as in the offline window, but with status icons
NOTE
NOTE:
Settings in the results window are linked to setting screens. This means the user can click in
the results window to navigate to the corresponding 8 Series settings window.
• Value: the converted value for the 8 Series settings file
• Original Name: set
ting name of the input file
• Or
iginal Value: setting value of the input file
CAUTION:
All other settings available (not shown in the conversion report) in the 8 Series file are
set to default and must be verified by the user before putting the relay into service.
NOTE
NOTE:
Custom curves from 469 cannot be converted to 869 although they appear in the
conversion report. Although settings show successful conversion, the user must still verify
the settings before putting the relay in service.
Status Icons
The status icon shows the conversion results:
Manual configuration required
Successful conversion
Value is not supported
Print Report If desired, the conversion summary report can be printed using the File/Print
command in the EnerVista taskbar or it can be printed from the “GUI” print button.