CHAPTER 4: SETPOINTS SETPOINTS MAIN MENU
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL 4–5
The relationship between a setpoint and input parameter is indicated by the following
symbols: “<” (less than), “>” (greater than), etc.
• P
ickup and Dropout Time Delays: Shown as a block with indication of two timers –
the t
PKP
(Pickup Delay), and t
DPO
(Dropout Delay).
• LED In
dicators: Shown as the following schematic symbol (X).
• Lo
gic: Described with basic logic gates (AND, OR, XOR, NAND, NOR). The inverter
(logical NOT), is shown as a circle: O
• Fle
xLogic operands: Shown as a block with a heading labeled ‘FLEXLOGIC OPERANDS’.
Each feature produces output flags (operands) which can be used further for creating
logic in the FlexLogic equation editor, or Trip Bus, or can be directly assigned to trigger
an output. The operands from all relay features constitute the list of FlexLogic
operands.
Setpoints Text Abbreviations
The following abbreviations are used in the setpoints pages.
•A: amperes
• kA: kiloamperes
•V: volts
• kV: kilovolts
• kW: kilowatts
•kvar: kilovars
• kVA: kilo-volt-amperes
• AUX: auxiliary
• COM, Comms: communications
• CT: current transformer
• GND: ground
•Hz: Hertz
• MAX: maximum
• MIN: minimum
• SEC, s: seconds
• UV: undervoltage
•OV: overvoltage
•VT: voltage transformer
• Ctrl: control
• Hr & hr: hour
•O/L: overload
• FLA: motor current at full load (Full Load Amperes)
To Next Page
Loading...
