GE MI-869 - Page 172

4–54 869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
DEVICE CHAPTER 4: SETPOINTS
LED 11 - Programmable
Name: OVERLOAD - Range: Up to 13 alphanumeric characters
Color: Green
Trigger: Motor Overload
Type: Self-reset
LED 12 - Programmable
Name: START INHIBIT - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Start Inhibit
Type: Self-reset
LED 13 - Programmable
Name: GROUND FAULT - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: GndFault OP
Type: Self-reset
LED 14 - Programmable
Name: HOT RTD - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Hot RTD
Type: Self-reset
LED 15- Programmable
Name: PB 1 - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Programmable Pushbutton 1
Type: Self-reset
LED 16- Programmable
Name: PB 2 - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Programmable Pushbutton 2
Type: Self-reset
LED 17- Programmable
Name: PB 3 - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Programmable Pushbutton 3
Type: Self-reset
NOTE
NOTE:
Assignment for Motor specific LED trigger operands are done as the default when a Set
point file is created in Enervista. If the relay’s HMI is used to program, the user must
configure these trigger assignments.