892800B8.PDF
869 E ** ** ** H * * A * N G * * * * * * * * * N
Interface 869 | | | |||||||||||||||||| 869 Motor Protection System
Language E | | | | | | | | | | | | | | | | | | | | English
Phase Currents ³
Slot J Bank 1/2
P1| |||||||||||||||||| 1A 3-phase current inputs (J1)
P5| |||||||||||||||||| 5A 3-phase current inputs (J1)
Phase Currents ³
Slot K Bank 1
NN | | | | | | | | | | | | | | | | | | No phase current inputs
P1 | | | | | | | | | | | | | | | | | | 1A 3-phase current inputs (K1)
P5 | | | | | | | | | | | | | | | | | | 5A 3-phase current inputs (K1)
Ground Currents G1 ||||||||||||||||| 1A ground input (J1)
G5||||||||||||||||| 5A ground input (J1)
B1|||||||||||||||||
1A ground (J1) + 50:0.025A
(K1, included with current protection M option only)
B5|||||||||||||||||
5A ground (J1) + 50:0.025A
(K1, included with current protection M option only)
0B||||||||||||||||| 50:0.025A (J1), only available if NN is selected for Slot K Bank 1
Power Supply L | | | | | | | | | | | | | | | | 24 to 48 V DC
H | | | | | | | | | | | | | | | | 110 to 250 V DC/110 to 230 V AC
Slot B - LV
IO
N||||||||||||||| None
R||||||||||||||| 6 X RTDS (PT100, NI100, NI120)
S||||||||||||||| 6 X RTDS (PT100, NI100, NI120, CU10)
Slot C- LV IO
N | | | | | | | | | | | | | | None
R | | | | | | | | | | | | | | 6 X RTDS (PT100, NI100, NI120)
S | | | | | | | | | | | | | | 6 X RTDS (PT100, NI100, NI120, CU10)
Slot F - HV IO A
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Form A (Vmon), 3 Form C, 7 Digital Inputs (Low/High Voltage, Int/Ext
Supply)
Slot G - HV
IO
N | | | | | | | | | | | | None
A |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Form A (Vmon), 3 Form C, 7 Digital Inputs (Low/High Voltage, Int/Ext
Supply)
L | | | | | | | | | | | | 7 DcmA O/P + 4 DcmA I/P + 1 RTD (PT 100, NI 100, NI 120)
Slot H - HV
IO
N||||||||||| None (High Voltage I/O)
F||||||||||| 10 Digital Inputs + 4 Arc Flash Inputs
A
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Form A (Vmon), 3 Form C, 7 Digital Inputs (Low/High Voltage, Int/Ext
Supply)
Faceplate M | | | | | | | | | | Basic = Membrane Keypad
G | | | | | | | | | | Standard = Rugged Keypad
Current Protection S | | | ||||||
Basic configuration: 14, 19, 37, 38, 46, 49, 50P, 50N, 50G, 50_2, 50LR,
51P, 51N, 51G, 66, 86
M
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Standard configuration: Basic configuration +67P, 67N, 87 (2nd CT Bank
required for 87)
Voltage Monitoring and Protection S
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Standard Voltage Monitoring & Protection: 24, 27P, 40, 40Q, 47, 59P, 59N,
59X, 81O, 81U, VTFF
P
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Advanced Voltage Monitoring & Protection: Standard Voltage
Monitoring & Protection +32, 55, 59_2, 78, 81R
Control B | ||||||
Basic control: Setpoint Group Control, Breaker/Contactor Control, Virtual
Inputs, Trip Bus
F||||||| Standard control: Basic control + FlexLogic, 50BF
Monitoring B
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Basic monitoring: Motor Health Report, Motor Start Report, Motor
Learned Data, Data Logger, Breakers Coil Monitoring, Breaker Arcing,
Harmonics, THD, Demand
C
|
|
|
|
|
|
|
|
|
|
|
|
Standard monitoring: Basic monitoring + Breaker Health Report, Broken
Rotor Bar
A | | | | | | Advanced: Standard + Harmonic Detection, Stator Inter-Turn Fault
Communications S E
|
|
|
|
|
|
|
|
Standard = USB, 1xRS485: Modbus RTU, DNP3.0, IEC60870-5-103 +
1xEthernet Copper: Modbus TCP, DNP3.0
1E
|
|
|
|
|
|
|
|
Advanced = USB, 1xRS485: Modbus RTU, DNP3.0, IEC60870-5-103 +
2xEthernet, Modbus TCP/IP, DNP3.0, IEC 60870-5-104, SNTP, 1588
1P|||| Advanced communications + PRP
2A|||| Advanced communications + IEC 61850
2E|||| Advanced communications + PRP + IEC 61850
Advanced Communications Connector N | | | None
S | | | ST, Multi-mode 1310 nm
C | | | RJ45, Copper 10/100M
Wireless Communication N | | None
W| | WiFi 802.11
Security B | Basic security
A | Advanced security: CyberSentry Level 1
Future Option N Not Available
To Next Page
Loading...
