GE NX-10 Installation Guide

NX-10 Expander Installation Guide
105
LOC DESCRIPTION DEFAULT PROGRAMMING DATA
Output 4
4 4 4 4 4 4 4 4 4 4
Output 5
5 5 5 5 5 5 5 5 5 5
Output 6
6 6 6 6 6 6 6 6 6 6
Output 7
7 7 7 7 7 7 7 7 7 7
Output 8
8 8 8 8 8 8 8 8 8 8
CODES 221-230 OUTPUT SELECTION (Circle numbers to program)
User 221 222 223 224 225 226 227 228 229 230
Output 1
1 1 1 1 1 1 1 1 1 1
Output 2
2 2 2 2 2 2 2 2 2 2
Output 3
3 3 3 3 3 3 3 3 3 3
Output 4
4 4 4 4 4 4 4 4 4 4
Output 5
5 5 5 5 5 5 5 5 5 5
Output 6
6 6 6 6 6 6 6 6 6 6
Output 7
7 7 7 7 7 7 7 7 7 7
90
Output 8
8 8 8 8 8 8 8 8 8 8
CODES 231-240 OUTPUT SELECTION (Circle numbers to program)
User 231 232 233 234 235 236 237 238 239 240
Output 1
1 1 1 1 1 1 1 1 1 1
Output 2
2 2 2 2 2 2 2 2 2 2
Output 3
3 3 3 3 3 3 3 3 3 3
Output 4
4 4 4 4 4 4 4 4 4 4
Output 5
5 5 5 5 5 5 5 5 5 5
Output 6
6 6 6 6 6 6 6 6 6 6
Output 7
7 7 7 7 7 7 7 7 7 7
91
Output 8
8 8 8 8 8 8 8 8 8 8
Programming examples
Possible application for outputs:
Example 1
Turn on entryway light upon entry only during nighttime.
Example 2
Turn a device on or off during business hours.
Example 3
Arm the system.
NOTE to example 3: The opening time is defaulted to 08.00h for all schedules. With this example, the NX-507E/NX-
508E will try to auto-arm after every 45 minutes of inactivity when the system is in ready state, from closing
time to opening time.
Feature selections to be programmed are shown in bold italic text.
Example 1: To have output 1 trip and activate an X-10 module with house code C and unit code 4
for 6 minutes when zone 1 is faulted only from 5:00 p.m. to 9:00 a.m., program the following:
Segment Segment Location
1 2 3
Location
1 2 3
0 42 1 3 3 3 2
1 1 32 9 0

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English