GE NX-10

NX-10 Expander Installation Guide
63
Table 8. NX-320-I auxiliary power module DIP switches
DIP switch 1-3 settings Address DIP switch 1-3 settings Address
84 88
85 89
86 90
87 91
= ON = OFF
Enrolling the NX-320-I auxiliary power module
1. Set DIP switches 1-3 to the correct address.
2. Select Enrol Modules>Enrol and press OK to enrol the NX-320-I auxiliary power
module. The enrolling process takes about 12 seconds. User codes are not accepted
during the enrolling process.