GE NX-10 Installation Guide

Table 4. NX-1701E proximity reader X-10 functions
Function Description Function Description
0 All units off 4 Dim
1 All units on 5 Bright
2 On 6 All lights off
3 Off
Adding and deleting cards
To add or delete cards, you must enter information at the keypad and then scan the cards. Before a
card can be added, one NX-1701E proximity reader on the system must be programmed to enable
user card programming. It is recommended that only one reader on the system is enabled to do this
and that this reader is located near a keypad. This NX-1701E proximity reader transfers information
to all other NX-1701E proximity readers in the system once programming is finished. The following
example enables user card programming on proximity reader 113.
Note: The proximity reader recognizes pre-defined card serial numbers. It is not recommended to change these
serial numbers.
1. Navigate with the ½¾ keys to NX-1701E>Prox Reader 113 and press OK.
2. Scroll to Feature Select>User Card Programming>Enabled and press OK.
3. The keypad beeps once to accept the change and returns to User Card Programming.
4. Enter a master user code to enter the user menu. Choose from one of the procedures outlined
below.
Table 5. NX-1701E tasks
Task Steps
Add one card
1. Select User Menu>NX-17xx Readers>Add One Card.
2. Enter the user number to be assigned to the card and press OK.
3. LED1 on any enabled readers begins to flash.
4. Scan the card designated for the entered user. If the user card is not already in the
system, it is added and LED1 stops flashing. If the card is already in the system, the reader
triple beeps and LED1 continues flashing.
5. 40 seconds after you have finished scanning, all the readers in the system are updated
with the new user card information.
Add multiple
users
1. Select User Menu>NX-17xx Readers>Add Multiple Cards.
2. Enter the user number to be assigned to the card and press OK.
3. LED1 on any enabled readers begins to flash.
4. Scan the card designated for the entered user. If the user card is not already in the
system, it is added and LED1 continues flashing indicating that the next user card can be
scanned. If the card is already in the system, the reader triple beeps and LED1 continues
flashing.
5. 40 seconds after you have finished scanning, all the readers in the system are updated
with the new user card information.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English