GE NX-10 Installation Guide

NX-10 Expander Installation Guide
117
Location Term Definition
10.1.3 Speaker Lockout A menu option that prevents the central station turning on
the speaker at the premises if a duress, silent panic or hold-
up alarm is reported by the control panel.
10.1.4 Mic A at Startup A menu option that activates microphone A when listen-in
commences.
10.1.5 Mic B at Startup A menu option that activates microphone B when listen-in
commences.
10.1.6 Answer Machine Defeat A menu entry used to defeat an answering machine. A
telephone call is made to the premises and is answered by
an answering machine or other device. If tone-sniff AMD is
enabled, only one call is required to defeat the answering
machine. The computer calls the panel as normal. When the
answering machine answers, the panel hears the tones from
the modem and seizes the phone line for a download.
10.1.7 Control Lvl 7&8 A menu option that enables level 7 and 8. This feature will
enable level 7 – status check and level 8 – arming/disarming
partition 1.
10.2 Call Back Code A menu option that specifies the code that starts a listen-in
session when the panel is in call back mode. This code can
be a maximum of six digits long.
10.3 Line Hold Digit A menu option that specifies the digit that starts a two-way
session when the control panel is in line hold mode.
10.4 Wrong PIN Digit Entries A menu option that specifies the maximum number of
incorrect digits that can be entered for call-back and call-in
features before the panel is locked out.
10.5 Rings to Answer A menu option that sets the number of rings that must occur
before the panel answers to start a listen-in session. If the
value is 0, the panel or the NX-534E will never react to an
incoming phone line and will never pick up the phone line.
Regulations in some countries do not allow a call in from an
installer or central station without approval by the end-user.
In this case the Answer U/D Call or Begin U/D Call menu
options should be used instead.
10.6 Timers A menu entry that groups timer options.
10.6.1 Line Hold Timeout A menu option that sets the length of time the listen-in
module will remain on the phone line with no activity from
the central station. This time can be set from 30 to 255
seconds. If it does not receive the digit within this time, the
listen-in module disconnects.
10.6.2 New Trip Hangup Time A menu option that sets the time at which the two-way
session timer is reset if a new event occurs in a partition
during a two-way session between the partition and the
central station.
10.6.3 Call Back Window Timer A menu option that sets the amount of time, in one-minute
increments, that the NX-534E listen-in module will wait to call
back after an alarm has been reported.
10.6.4 Session Timeout A menu option that defines how long the listen-in module
remains on the phone line with no activity from the central

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English