GE NX-10

For general information about navigating menus, and entering or selecting values, see Chapter 1
Programming guidelines on page
8. For general information about location-based programming, see
Guidelines for location-based programming on page 10.
The basic menu structure is as follows:
Figure 1. Installer menu overview
Note: All the menu diagrams in this manual comply with the menu order and numbering used in the NX-10 Menu
Diagram and described in
Figure 1.
For information about programming the control panel, keypads, RF receivers and GPRS module, see
the NX-10 Installers Manual.
1.
Control Panel 2.
This Keypad 3.
Other keypads 4.
RF Receivers 5.
6.
NX-216 Input Expanders
7.
NX-320 Power Modules
8.
NX-50x Output Expanders
9.
NX-534 Listen-in Module
1.0
NX-535 Voice Module
1.1
NX-584 Home Automation
1.2
NX-586 Direct Connect
1.3
NX-590E TCP/IP
1.4
NX-7002 GPRS Module
1.5
NX-910x VVM
1.6
Enrol Modules
1.7
Maintenance Mode
1.8
OK=LOC =MENU
NX-1701 Proximity Readers
1.9
NX-1750 Proxpad