LOCATION 1 - CALLBACK ACCESS CODE (default = 123456) (6 segments, feature selection
data)
Location 1 contains the access code used to start a listen-in session when the NX-534E is in a
callback mode. The callback access code can be up to a maximum of 6 digits. The valid entries are 0-
15 (10 = *, 11 = , 12 = none, 13 thru 15 = any digit). If less than six digits are desired, program a
“15” at the end of the desired code. If location 1 contains a “15”, any digit will access the NX-534E.
If segment 1 contains a “12”, no access code is required.
LOCATION 2 - LINE HOLD MODE ACCESS DIGIT (default = 15(F)) (1 segment, numerical data)
Location 2 is used to determine the line-hold access digit. This digit is required to start a two-way
session if line-hold mode is used. Valid entries are: 0 - 15 (10 = *, 11 = #, 12 = none, 13 thru 15 =
any digit). If location 2 contains a “15”, any digit will access the NX-534E. If location 2 contains a
“12”, no access digit is required.
LOCATION 3 - TIMING OPTIONS (8 segments, numerical data)
Segment 1 - Line hold timeout (default = 60 seconds)
Location 3, segment 1 determines how long the NX-534E will wait for the line-hold digit
programmed in location 2 while in the line-hold mode. After a digit is pressed, the timer will reset. If
the digit is not received during this time, the NX-534E will hang-up (disconnect). This time is
programmable from 10 to 255 seconds for each digit.
Segment 2 - New trip hang-up time (default = 20 seconds)
Location 3, segment 2 is used to determine where the NX-534E will set the session timer when a new
trip is received on the same partition during a two-way session. This time is programmed from 1 to
255 seconds, and will be extended if there is any activity from the central station. If an alarm occurs
in the same partition, pressing a key in this time period will extend the session timer. If the alarm is
in a different partition, the timer will be reduced automatically and will now allow the timer to be
restarted.
Segment 3 - Callback window timer (default = 5 minutes)
Location 3, segment 3 will determine the amount of time, in 1-minute increments, the NX-534E will
wait for a callback when enabled in location 0, segment 1 or initiated by the central station (see also
“control levels” on page 6). Possible increments are 1 to 255 minutes.
Segment 4 - Wrong pin entries (default = 12)
Location 3, segment 4 determines the maximum number of attempts that can be made to enter valid
access codes for callback and call-in features. Refer to location 0, segments 1 and 6. Valid entries are
6 - 255 attempts. Default is set for 12 attempts.
Segment 5 - Session inactivity hang-up time (default = 90 seconds)
Location 3, segment 5 is used to determine how long the NX-534E will remain on the phone line
with no activity from the central station. This time can be programmed from 30 to 255 seconds.
To Next Page
Loading...
Need help?
General
